How to install the sonde, spring and camera head on your Insight Vision Opticam or Vutek sewer camera system
Insert the male end of the sonde in the wide end spring, then shake it to reveal the sonde end.
Line up the three large holes and one small hole, plugging the male into the female end and twist on. Push sonde further into the spring making it easier to insert the strain reliefs.
Hand tighten the spring on to the small end. Be sure not to overtighten the spring on the termination. Grab the camera head and plug the male end into the female end of the cable, lining up the three large holes and one small hole.
Screw the bushing back on. Put the strain reliefs in the notches, holding them in place with your fingers as you screw the spring clockwise on to the camera head. Once again be sure not to overtighten the spring.
Turn on the system to be sure your camera head is working.
Insight | Vision is an advanced inspection manufacturer for many industries but mainly for pipes, drains and sewers lines.
